Surface Preparation

• Remove debris from greyed wood with a stiff brush or broom; afterwards dampen with water.

• Wood Reviver Power-Gel is ready to use. Do not thin.
  

• Perform a trial application before treating wood with Wood Reviver Power-Gel.

Method Of Application

• Generously apply the gel along the wood grain. After approx. 20 minutes reaction time, clean surface with Osmo Decking Cleaning Brush and rinse with plenty of water. Avoid pressure / jest washers for cleaning as they can significantly increase absorbency of  some timbers ( eg soft timbers) . After drying for approx 2-3 days in clement weather conditions, protect the newly refreshed wood with a wood finish (e.g. for decks – Osmo Natural Oil Woodstain or Osmo Decking-Oils). Check the moisture content of the wood is less than 20% RM prior to applying an Osmo wood finish.

Note

• Osmo Wood Reviver Gel is most effective when applied onto bare, untreated timber. Existing treatments may block the revival process – always trial apply first. Protect/cover sensitive surfaces such as: plants, metallic components ( eg aluminium), sensitive stones and renders. After treatment the dried wood may appear quite light in colour. The fully refreshed colour of the wood should be revealed following the application of an Osmo finishing oil.

• Dampen the surface with water first, and apply the gel generously with a brush. It may be possible to achieve immediate cleaning results. Test the surface with a scrubbing brush along the grain of the timber to check performance. If necessary, leave to soak for 20 minutes and scrub with a hard bristle brush or scrubber. Once cleaned, rinse with plenty of fresh water and allow to dry.
• Avoid using a pressure / jet washer to rinse the wood as this may damage the wood and significantly increase it’s absorbency.
• Wood Reviver is most effective when applied onto bare, untreated timber as certain treatments may block the revival process – always trial apply.
• Protect sensitive surfaces such as: plants, metallic components ( eg aluminium), sensitive stones and renders.
• After drying the wood may appear quite light in colour. The true, refreshed colour of the wood will be revealed following the application of an Osmo finishing oil.
• Surface can be finished after 2 – 3 days in good drying conditions. The moisture content of the wood should be below 20%RM prior to application.
• Depending on the extent of the greying, rinsing with water may be sufficient or a stiff brush may be necessary to scrub clean the surface. The process may need to be repeated for severe greying.

• Osmo Wood Reviver Power-Gel is highly recommended for timber decking, cladding, garden furniture and similar surfaces.

• 10m²/L with one application, depends on condition of the wood

    PRODUCT DATA SHEET | DOWNLOAD

    SAFETY DATA SHEET | DOWNLOAD